Reznor R6GI Unit Installation Manual Manual do Utilizador descarregar pdf (Página 4)

• Theinstallershouldbecomefamiliarwiththeunitswiring

diagram before making any electrical connections to the

unit. See the unit wiring label or Figure 17 (page 34)

& Figure 18 (page 35).

REQUIREMENTS & CODES

• Thisequipmentmustbeinstalledinaccordancewith

instructions outlined in this manual, all applicable

localbuilding codes,and thecurrent revisionof

the National Fuel Gas Code (NFPA54/ANSI Z223.1)

or the Natural Gas and Propane Installation Code,

CAN/CGA B149.1.

• Allelectricalwiringmustbecompletedinaccordance

with local, state and national codes and regulations

and with the National Electric Code (ANSI/NFPA 70)

or in Canada the Canadian Electric Code Part 1 CSA

C.22.1.

• The installer must comply with all local codes and

regulations which govern the installation of this type

of equipment. Local codes and regulations take

precedence over any recommendations contained in

these instructions. Consult local building codes and the

National Electrical Code (ANSI CI) for special installation

requirements.

• Thisequipmentcontainsliquidandgaseousrefrigerant

under high pressure. Installation or servicing should only

be performed by qualiﬁed trained personnel thoroughly

familiar with this type equipment.

• Air Ducts must be installed in accordance with the

standards of the National Fire Protection Association

“Standards for Installation of Air Conditioning and

Ventilation Systems” (NFPA 90A), “Standard for

Installation of Residence Type Warm Air Heating and Air

Conditioning Systems” (NFPA 90B), these instructions,

and all applicable local codes.

• Consult Table 12, (page 27), Table 13, (page 27),

& Table 14, (page 27), and the rating plate for the

proper circulating air ﬂow and temperature rise. It is

important that the duct system be designed to provide

the correct ﬂow rates and external pressure rise. An

improperly designed duct system can result in nuisance

shutdowns, and comfort or noise issues.

• Thisunitisdesignedforoutdoorinstallationsonlyand

should be located in a position as shown on page 5.

• Use onlywiththe typeof gasapproved forthis unit.

Refer to the unit rating plate.

• Provideadequatecombustionandventilationairtothe

unit. See pages 6 – 7.

• Provideadequateclearancesaroundthecombustion

air intake louvers. See Figure 1 (page 5).

• Combustion products must be discharged outdoors.

Connect this unit to an approved vent system only, as

speciﬁed on page 7.

• Additionalcodeslistedbelowareforreferencepurposes

only and do not necessarily have jurisdiction over

local or state codes. Local codes and regulations take

precedence over any recommendations contained in

these instructions. Always consult with local authorities

before installing any gas appliance.

Combustion & Ventilation Air

• US:NationalFuelGasCode(NFGC),AirforCombustion

and Ventilation

• CANADA: NaturalGasandPropaneInstallationCodes

(NSCNGPIC), Venting Systems and Air Supply for

Appliances

Duct Systems

• USandCANADA:AirConditioningContractorsAssociation

(ACCA) Manual Q, Sheet Metal and Air Conditioning

Contractors National Association (SMACNA), or American

Society of Heating, Refrigeration, and Air Conditioning

Engineers (ASHRAE) Fundamentals Handbook

Electrical Connections

• US:NationalElectricalCode(NEC)ANSI/NFPA70

• CANADA:CanadianElectricalCodeCSAC22.1

Gas Piping & Gas Pipe Pressure Testing

• US:NFGCandNationalPlumbingCodes

• CANADA:NSCNGPIC

General Installation

• US:CurrenteditionoftheNFGCandtheNFPA90B.For

copies, contact the National Fire Protection Association

Inc., Batterymarch Park, Quincy, MA 02269; or American

Gas Association, 400 N. Capitol, N.W., Washington DC

20001 or www.NFPA.org.

• CANADA:NSCNGPIC.Foracopy,contactStandardSales,

CSA International, 178 Rexdale Boulevard, Etobicoke

(Toronto), Ontario, M9W 1R3 Canada

Safety

• US: (NFGC) NFPA 54–1999/ANSI Z223.1 and the

Installation Standards, Warm Air Heating and Air

Conditioning Systems ANSI/NFPA 90B.

• CANADA: CAN/CGA-B149.1–and .2–M00 National

Standard of Canada. (NSCNGPIC)

1 2 3 4 5 6 7 8 9 ... 39 40

Comentários a estes Manuais

Sem comentários

Reznor R6GI Unit Installation Manual Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Radiadores Reznor R6GI Unit Installation Manual